Beretta.net

Ha that sound coming from the back was off all things the exhaust rattling up against the axle where it goes over it... the hanger for the thrush glasspack broke along with one back at my muffler I had to coat hanger the **** up to prevent it from haning low... I will have to get it taken care of wh...

Well I dont understand how eibachs are a "direct replacement" for stock springs because when you would have both side by side on the ground and make sure the bottom of the spring is in the same direction and then you look at the top the eibachs coil ends about 90-120 degrees after the stoc...

Will do thanks rex.

Well I just installed the new KYB struts with new Eibach springs and taking it out for a drive I was getting a clunking sound.   Thought it might have been the tierods but it turns out after looking at a strut while my friend turned the wheel that the spring itself is rotating (giving away and makin...

Creaking was present before Z51 which didn't make the noise increase or decrease. I am pretty sure its the axle/frame bushings... figure the car is sitting lower so they are moving a little bit past where they would normally be... Also I noticed the creaking today when I would put the breaks on to c...

I just installed the GR-2's and the Eibachs this night (first the GR-2's drove to work 10 minutes away then when I got home put in the rear springs. I have a question though, I am using the stock insulators for the springs right now and stock mounts for the shocks... Should I actually replace these?...

Unfortunately that is the only place offering tuning hardware/software for 96 ECM's

Hmmmm... what is the part number for your ECM...

I use a BURN1 Unit by moates for tuning.

looking good there man.

haha I am not going to paint any caps gold.  I am going to put an a badge though that has the red replaced with gold for the front  bowtie though.  This was the exact "gold" I wanted too... the same color found on trans ams/camaro ground effects from the late 80's early 90's Next thing on ...

Wonder how my HP the Gold gives me??? I am not finished with the strut tower brace either... BTW the strut tower was WELL worth 45 bucks... Pick one up before they are gone! Kinda in the first stages after stripping the original junk off... Thanks to dennis for his method except that aircraft stripp...

91 has the cutoff... works when your TPS sensor reads at WOT it sends a signal to your ECM to disengage your compressor clutch

This means race with your A/C to keep cool  

This is to all the beretta owners with the TRS header installed... I have heard from a few people it hangs to low... First is this true??? I will be installing my Eibach springs and a set of KYB Struts/Shocks once they come. Is this due to the fact that the mock up car for the headers constrution wa...

That's a sweet deal... Design some heads for the 3x00 crowd now and slap another 20 or so hp to the wheels  

(wicked-irocz @ Jan. 17 2006,11:44)Q U O T Enot bad for a $68 camera, now how long it keeps working, thats the real test. It's a 7.2mp Sony DSC P150   It was a close out we had at sears and me being in the electronics department got it the second it was maked down to 75 bucks final price (used disco...

Well last night I wanted to see how well my camera handled low light without using its flash.  I had to use my little tripod due to the exposure time is about 2 seconds. Here are some pics infront of some tanks at a brewery called Stoudts These are by an assembly plant for penske moving trucks and a...