Search found 2744 matches
- Sat Sep 24, 2016 8:38 pm
- Forum: Diagnostic Help
- Topic: Gtz will not go in first. Thoughts?
- Replies: 2
- Views: 2287
Re: Gtz will not go in first. Thoughts?
Bad cable is my guess, for easier checking purposes.
- Sun Sep 18, 2016 6:44 pm
- Forum: For Sale
- Topic: 88 GTU "shell" with 70k, Sheboygan, WI 53081
- Replies: 33
- Views: 16362
Re: 88 GTU "shell" with 70k, Sheboygan, WI 53081
must resist...
- Sat Sep 10, 2016 7:58 am
- Forum: Diagnostic Help
- Topic: Beretta dies when trying to leave from idle, help needed
- Replies: 27
- Views: 12329
Re: Beretta dies when trying to leave from idle, help needed
FPR or injectors were never verified for being good?
- Fri Sep 09, 2016 9:42 pm
- Forum: Members Rides
- Topic: 1996 Mr.Pink
- Replies: 1372
- Views: 415017
Re: 1996 Mr.Pink
bearing setup, shaft use?
- Fri Sep 09, 2016 8:35 pm
- Forum: Members Rides
- Topic: 1996 Mr.Pink
- Replies: 1372
- Views: 415017
Re: 1996 Mr.Pink
Any possibility in a T-Case for scavenging parts, or VersaTrak components?
Not sure the "interchangeability" of those to the dedicated fwd transverse transmissions.
Not sure the "interchangeability" of those to the dedicated fwd transverse transmissions.
- Fri Sep 09, 2016 11:16 am
- Forum: Members Rides
- Topic: 1996 Mr.Pink
- Replies: 1372
- Views: 415017
Re: 1996 Mr.Pink
What was the past reasoning of going without this sooner?3X00-Modified wrote: Future updates... After testing
4t65e 4th gear hub, and clutches if needed, which means I can finally use a 4t65e-HD output shaft!!! and not a 1 year 60e-hd output shaft which is hard to find!
- Mon Sep 05, 2016 6:53 pm
- Forum: Diagnostic Help
- Topic: Beretta dies when trying to leave from idle, help needed
- Replies: 27
- Views: 12329
Re: Beretta dies when trying to leave from idle, help needed
Checking it off vehicle may not expose a bad connection/harness. Re-check it while on vehicle to see what the ecm is receiving and if they coincide with each other.
- Mon Sep 05, 2016 11:22 am
- Forum: Diagnostic Help
- Topic: Beretta dies when trying to leave from idle, help needed
- Replies: 27
- Views: 12329
Re: Beretta dies when trying to leave from idle, help needed
Codes? Check tps voltage readings? it should sweep pretty smoothly in values.
- Sat Sep 03, 2016 9:55 pm
- Forum: Board Suggestions
- Topic: Plate Frames
- Replies: 8
- Views: 39429
Re: Plate Frames
"Beretta.net, no CPL required"
or..
"Beretta.net; right to bare arm, out of driver's door"
or..
"Beretta.net; right to bare arm, out of driver's door"
- Sat Sep 03, 2016 4:55 pm
- Forum: Board Suggestions
- Topic: Plate Frames
- Replies: 8
- Views: 39429
Plate Frames
More of a site sponsoring tactic then a board suggestion, not sure if there is a dedicated subsection? Would a plate frame be beneficial to our community? Most car sites stash a couple in a "goodie" bag and offer them for purchase throughout the year to promote the club/site. Some are plas...
- Fri Sep 02, 2016 7:00 pm
- Forum: General Discussion
- Topic: com
- Replies: 11
- Views: 4989
Re: com
LoL ya did ya did.
- Fri Sep 02, 2016 3:18 pm
- Forum: General Discussion
- Topic: com
- Replies: 11
- Views: 4989
Re: com
Pointless probably to know; I used to be very slacking at changing the calendar over to the next month, but the b.net calendar drives me to maintaining the correct month exposed!
- Mon Aug 29, 2016 6:31 am
- Forum: Members Rides
- Topic: I'm still here
- Replies: 42
- Views: 20196
Re: I'm still here
Fuel may be viewed as low buck in the states, but the road conditions and responsibilities pay its toll for owning the vehicle. Road conditions are and not limited to, pavement quality, construction detours, annual ownership fees, insurance rates, moronic drivers... quick and nimble is nice when cou...
- Mon Aug 29, 2016 5:52 am
- Forum: Members Rides
- Topic: I'm still here
- Replies: 42
- Views: 20196
Re: I'm still here
Being compared to the dinosaur 3.1 says a lot. I wonder if or how much pcm tuning would turn that focus in to a different drive experience? Go from sloth to loch ness Monster on meth potentially? You think a set of poly mounts would improve the shifting ability? Does it grind when trying to fast shi...
- Sun Aug 28, 2016 4:46 pm
- Forum: Members Rides
- Topic: I'm still here
- Replies: 42
- Views: 20196
Re: I'm still here
Interesting choice. The diesel would've been my pick, but only be/c I have had my share of gutless 4 bangers in a car of that size or larger.