Beretta.net

Ran 3dmark 11 and 3dmark vantage. They both seem kind of low. Neither one are reading my correct gpu clock speed though.

3dmark11 : P4016
3dmark vantage :17404

Hey wanako have you tried any benchmarks? I always like to see what kind of scores people get. Build looks good. In the pic with the side open are the hard drives plugged in? I can't tell if the cables come out the front and around the back or if they are just not plugged in. Also does the bottom of...

Haha. Yeah. I am still alive. I have been reading the boards just not posting much. Haven't really touched the beretta in a few months either. Both my other cars had issues that needed to be taken care off. One being the heat blowing the fuse. Took me forever to find the problem. Replaced switches a...

Nice!!! Good job with the cable management. I love a clean computer case. Love the HAF series cases. Have you run any 3dmark tests yet. I got mine up to the 25,2xx mark. I upgraded to water cooled since the OP and overclocked it a tad more to 4.2GHz. The water is a HUGE improvement over the air cool...

Vehicle has been sold.

You can hit the tie rod end with a hammer if you plan on replacing them. I keep the nut on but lined up with the end to give it a little more surface area.

Yeah, That would be nice. This is the third time I have replaced it since I have owned the car. I don't even put that many miles on it. The turn signals was the fuse for my brake lights. Probably blew when I reconnected the battery or something. Oh well it works and I can drive it a bit before any m...

Got it running again. Magnetic pickup sensor went bad again. Went for a test drive and now the turn signals don't work. Ugh.

Fixed it. Bad brake light fuse.

Holy Crap.

It is not very difficult. Remove wheel Remove ball joint and support the wheel hub. If you have fe7 suspension then you have to disconnect the sway bar end link.. If not you can keep the sway bar attached and drop it with the sub frame. Remove dog bone motor mount. Each end of each sub frame has 2 b...

Proof would be any of the following: Paypal Payment Info Proof a money order (check) was received and cashed Tracking #'s any type of delivery confirmation That is what I can think of right now. I don't see the issue with the VIN number being posted. Tons of them are posted online via car buying web...

No need to take out the dash for heater core replacement. Follow this how to and you should be fine.

I took out my front seats to lay down. I think it made it much easier.

http://www.beretta.net/forum/viewtopic.php?f=3&t=3873

Nice

Another way to check some steering and suspension parts is to jack up the wheel and grab it at 3 and 9 o'clock and and try to move it back and forth. Then do the same at 12 and 6. This can help determine if a ball joint or tie rod end needs replacing. Also a wheel hub sometimes.

Just got home. Had more vehicle problems on Sunday. On the way back from lunch at the Holy Grail I noticed the clock was wrong in the truck. We got back to the hotel and looked up movie times. Went back out to the truck to leave and saw the clock was reset again and it had trouble starting but it di...