Non-ABS master cylinder ports

woody90gtz · Post by **woody90gtz** » Tue Jul 16, 2013 9:22 am

Can anyone with a pre-92 master check the ports and which line goes where? I'm replacing all the flare nuts and would like to double check the layout. I used a 94+ brake/fuel line assembly in my 91 and had to change a flare nut for it to work. Everything worked well, but I'd just like to double check that everything is correct, because now would be the time to change it in case.

Top front -
Bottom front -
Top rear -
Bottom rear -

Asylum · Post by **Asylum** » Tue Jul 16, 2013 9:28 am

I will check mine a little later today if no one beats me to the answer.

Asylum · Post by **Asylum** » Tue Jul 16, 2013 9:43 am

Here's what I found on V6Z24.com

Top front: Left Front
Top Rear: Right Front
Bottom Front: Right Rear
Bottom Rear: Left Rear

woody90gtz · Post by **woody90gtz** » Tue Jul 16, 2013 10:24 am

Ok, my car was right. The pattern is different from what I would have expected (front lines from the bigger ports in rear), but it works! Thanks old man.

Asylum · Post by **Asylum** » Tue Jul 16, 2013 10:35 am

You're right it does seem weird, so I went and looked at mine.

That is correct.

stargazer7467 · Post by **stargazer7467** » Fri Jan 31, 2014 8:41 am

i used this pic for the abs delete on the sunfire. I used a corsica M/C iirc.

Beretta.net