NVG T550 disassembly.

If there isn't a place for your question then put it here.
Post Reply
User avatar
Barry
Global Moderator
Posts: 1871
Joined: Fri Feb 29, 2008 8:11 pm
Location: Hatfield Pa

NVG T550 disassembly.

Post by Barry »

Heres where I am at. How do I remove the shafts from the trans? Theres no bolts there like there is on the getrags...

Image


User avatar
3400beretta
Registered User
Posts: 281
Joined: Fri Mar 10, 2006 2:21 am

Re: NVG T550 disassembly.

Post by 3400beretta »

Kinda hard to see from the pic, but I think I know what you are talking about.
There hex head bolts there, they are reverse threaded though.

I had to buy a special hex drive socket IIRC it is 12mm. Used an impact gun to get em out.


User avatar
Barry
Global Moderator
Posts: 1871
Joined: Fri Feb 29, 2008 8:11 pm
Location: Hatfield Pa

Re: NVG T550 disassembly.

Post by Barry »

Thanks Rodney, I'll look into it further. It looks like roller bearings in there, but maybe there hex. I hope so


User avatar
3400beretta
Registered User
Posts: 281
Joined: Fri Mar 10, 2006 2:21 am

Re: NVG T550 disassembly.

Post by 3400beretta »

Yep, I believe they are 12 point hex so yeah at a quick glance would look like needle bearings.


User avatar
Barry
Global Moderator
Posts: 1871
Joined: Fri Feb 29, 2008 8:11 pm
Location: Hatfield Pa

Re: NVG T550 disassembly.

Post by Barry »

3400beretta wrote:Yep, I believe they are 12 point hex so yeah at a quick glance would look like needle bearings.
I am praying that your right. Thanks!


Post Reply