Page 1 of 1

Plate Frames

Posted: Sat Sep 03, 2016 4:55 pm
by 1988GTU
More of a site sponsoring tactic then a board suggestion, not sure if there is a dedicated subsection?

Would a plate frame be beneficial to our community? Most car sites stash a couple in a "goodie" bag and offer them for purchase throughout the year to promote the club/site. Some are plastic, some are billet aluminum, some are steel, it's all based on resources and such. Aluminum is nice, but the material was basically low cost and the water jet used was "donated" for the production run.

Just tossing ideas around that may trigger a bulb to flicker on to those that could make it happen, if something like that is even of the community's interest.

Re: Plate Frames

Posted: Sat Sep 03, 2016 7:04 pm
by heavywoody
I'd rock one that said "My other car is a Beretta"

Re: Plate Frames

Posted: Sat Sep 03, 2016 9:55 pm
by 1988GTU
"Beretta.net, no CPL required"
or..
"Beretta.net; right to bare arm, out of driver's door"

Re: Plate Frames

Posted: Sun Sep 04, 2016 1:13 am
by Cliff8928
heavywoody wrote:I'd rock one that said "My other car is a Beretta"


This! I totally need one of these! I've never found one that I could get that didn't look generic though.

Re: Plate Frames

Posted: Sun Sep 04, 2016 6:48 pm
by Asylum
"My Other Car Is a Beretta! What Could Possibly Go Wrong?"

Re: Plate Frames

Posted: Wed Sep 07, 2016 12:09 pm
by ronaconda
I'd rock one!!!

Re: Plate Frames

Posted: Wed Feb 01, 2017 6:28 pm
by jewelblackbird
If you are going to take the time to make them you could have a lot of other items made too key rings with Beretta or Beretta.net logo (car) and I know everyone can always use a bottle opener (for those of us beer lid does not twist off).