Beretta.net

I cant remember dude, but are you still planning a back seat or just a 2-seater?

Sent from my VS840 4G using Tapatalk

No back seat .....gonna be a rear firewall and roll cage .....for what I wanna run u need main hoop, wirh harness bars, two bars that go from main hoop to rear strut/frame and at least one diagonal between those......not really to much room left for seats.....just gonna block it all off.

Pass side seat bracket done and fresh coat of paint ...found manual (non power) drivers side bracket....just waiting for it to arrive and do the same mod and seat brackets are done

Those look like Cavalier seat brackets!

Those are very similiar to the set of seat brackets that I used for my GTZ seat swap into my 94 Cavalier back in the day!

both front seat brackets finished and seats and doors have been test fitted. Everything seems to be lining up nice

MORE BURNOUTS!

Keep up the good work!

Lookin awesome man! Any pics of the doors on during test fit?

Sent from my VS840 4G using Tapatalk

Hahaha I couldn't roll the car out to get a pic cause I took the rear axle out again.......the good news is the rear end is being rebuilt with a new carrier with a 373s and all fresh seals .....I knew I should have snapped a quick pic with the doors on damit

I really just waned to make sure the doors didnt hit the seat bolsters when shut......and to make sure there was enough room for the door bars (roll cage) between the seats and door inner with out cut to g the inner door shell out.. ......but there was plenty of room......

Didnt really get any real work done today......took the seats back out .....I actually made a to do list ......its got a "few" things on it .......didnt look too scary though......

Not sure if I ever posted these .......but I had a custom made Z28 door decals and rear facia decal made to match location and size of what would have been a Z26 decals

Too bad the cars gonna have a full cage. Would have been sic with no cage and appear stock even when you open the doors.

But! This work is still amazing! Still eating my popcorn buddy!

Sent from my VS840 4G using Tapatalk

Depending on how custom he wants to go - he could tie it into the A and B pillar really well and hide it.

Also - with as much as this car has been cut up and re-welded - at a minimum I would put in subframe connectors and a cage...

Jjanke - keep on going and please keep us updated!

crap you're gonna beat me to being done! haha

Car is about as far from stock as you can get...I wouldn't worry too much about hiding the cage. What colors are the Zcals? I assume it's staying white too?