air conditioning dash vents

Keep this to general Beretta/Board/Community topics.
kmkk1010
Registered User
Posts: 21
Joined: Sat May 28, 2016 11:34 pm

air conditioning dash vents

Postby kmkk1010 » Thu Sep 29, 2016 4:01 am

hi everyone. does anyone know how to remove an air conditioning dashboard vent? on one of my vents, the vanes are going in all different directions and I would like to remove the vent in order to repair it. Thanks!!



User avatar
Money pit Beretta
Registered User
Posts: 6362
Joined: Thu Jul 26, 2007 11:36 am
Location: Kansas
Has thanked: 2 times
Been thanked: 9 times

Re: air conditioning dash vents

Postby Money pit Beretta » Thu Sep 29, 2016 7:52 am

Just need to pry the sides of the vent with care. Take it slow and easy(don't need a lot of pressure). You can use a thin/small screwdriver. There is a circle on the sides of the vents that is held by a clip on the dash. If you have two screwdrivers that might make it pop out with more ease.


keep'em flying!

kmkk1010
Registered User
Posts: 21
Joined: Sat May 28, 2016 11:34 pm

Re: air conditioning dash vents

Postby kmkk1010 » Fri Sep 30, 2016 3:34 am

okay thank you money pit Beretta! So it's kind of like how a toilet paper roll goes into the holder. I will try it very carefully just like you said, as I am sure the plastic is very brittle. thanks again!



User avatar
Money pit Beretta
Registered User
Posts: 6362
Joined: Thu Jul 26, 2007 11:36 am
Location: Kansas
Has thanked: 2 times
Been thanked: 9 times

Re: air conditioning dash vents

Postby Money pit Beretta » Fri Sep 30, 2016 6:54 pm

If it's on the cup holder side you could take off the cup holder and the part that covers the vents will come with it. The center where the radio is comes out without screws. Start from the top and work your way down, prying with just your fingers.


keep'em flying!


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 6 guests