Computer codes

Frequently Asked Questions
Post Reply
oldadmin
Registered User
Posts: 48
Joined: Sat Sep 08, 2001 3:35 pm

Computer codes

Post by oldadmin »



1988GTU
Registered User
Posts: 2744
Joined: Sat Mar 23, 2002 1:06 pm
Location: A town up north

Computer codes

Post by 1988GTU »

That link no workie.  


_________
Image
-------------
User avatar
HateMyAuto
Registered User
Posts: 221
Joined: Thu Feb 03, 2005 9:56 pm
Location: Tallahassee Fl

Computer codes

Post by HateMyAuto »

These are the codes pulled for a 96 automatic, so I'm not sure if they are the same for the OBD 1s or manuals. If you get a code and it's not listed here, lemme know and I'll find out.

PCM codes:
P0101 - Mass air flow system performance
P0102 - MAF sensor circuit low frequency
P0103 - MAF sensor circuir high frequency
P0106 - MAP system performance
P0107 - MAP sensor circuit low voltage
P0108 - MAP sensor circuit high voltage
P0112 - IAT sensor circuit low voltage
P0113 - IAT sensor circuit high voltage
P0117 - ECT sensor circuit low voltage
P0118 - ECT sensor circuit high voltage
P0121 - TP sensor performance
P0122 - TP sensor circuit low voltage
P0123 - TP sensor circuit high voltage
P0125 - ECT excessive time to closed loop
P0131 - HO2S circuit low voltage sensor 1
P0132 - HO2S circuit high voltage sensor 1
P0133 - HO2S circuit slow response sensor 1
P0134 - HO2S CKT insufficient activity sensor 1
P0135 - HO2S Heater circuit sensor 1
P0137 - HO2S circuit low voltage sensor 2
P0138 - HO2S circuit high voltage sensor 2
P0140 - HO2S CKT insufficient activity sensor 2
P0141 - HO2S Heater circuit sensor 2
P0171 - Fuel trim system lean
P0172 - Fuel trim system rich
P0300 - Engine misfire detected
P0325 - Knock sensor module circuit
P0326 - Knock sensor noise channel high voltage
P0327 - Knock sensor noise channel low voltage
P0336 - 24X reference signal circuit
P0341 - CMP sensor circuit performance
P0401 - EGR system flow insufficient
P0420 - TWC system low efficiency
P0441 - EVAP system no flow during purge
P0502 - Vehicle speed sensor circuit - low input
P0506 - Idle control system low RPM
P0507 - Idle control system high RPM
P0530 - A/C refriderant pressure sensor circuit
P0560 - System voltage
P0601 - PCM memory
P0602 - PCM not programmed
P0705 - Trans range switch circuit
P0706 - Transaxle range switch performance
P0712 - Transaxle fluid temperature sensor circuit - low signal voltage
P0713 - Transaxle fluid temperature sensore circuit - high signal voltage
P0719 - Brake switch circuit low
P0724 - Brake switch circuit high
P0742 - Torque converter clutch circuit stuck on
P0751 - Shift solenoid 1 - Performance/Stuck on
P0753 - Shift solenoid 1 - Electrical
P0756 - Shift solenoid 2 - Performance/Stuck off
P0758 - Shift solenoid 2 - Electrical
P1106 - MAP sensor CKT intermittent high voltage
P1107 - MAP sensor CKT intermittent low voltage
P1111 - IAT sensor CKT intermittent high voltage
P1112 - IAT sensor CKT intermittent low voltage
P1114 - ECT sensor CKT intermittent high voltage
P1115 - ECT sensor CKT intermittent low voltage
P1121 - TP sensor CKT intermittent high voltage
P1122 - TP sensor CKT intermittent low voltage
P1133 - HO2S Insufficient switching sensor 1
P1134 - HO2S transition time ratio sensor 1
P1200 - Injector control circuit
P1350 - Bypass line monitor
P1361 - IC circuit not toggling
P1374 - Reference circuit
P1406 - EGR valve pintle position circuit
P1441 - EVAP system flow during non-purge
P1442 - EVAP vacuum switch circuit
P1554 - Cruise control status circuit
P1635 - 5 volt reference (A) circuit
P1639 - 5 volt reference (B) circuit
P1641 - MIL control circuit
P1651 - Fan 1 relay control circuit
P1654 - A/C relay control circuit
P1655 - EVAP purge solenoid control circuit
P1662 - Cruise control inhibit control circuit
P1672 - Low engine oil level lamp control circuit CKT
P1673 - Engine hot lamp control circuit
P1812 - Transaxle over temperature condition
P1860 - Torque converter clutch PWM solenoid circuit
P1864 - Torque converter clutch enable solenoid circuit
P1870 - Transaxle component slipping

Airbag codes:
14 - Arming sensor disconnected
21 - Driver initiator circuit resistance high
22 - Driver initiator circuit resistance low
23 - Driver initiator circuit voltage high
24 - Driver initiator circuit voltage low
25 - Driver initiator circuit short to ignition
26 - Driver initiator circuit open
28 - Current sink or source failure
31 - Driver loop energy reserve feed open
34 - Arming sensor ignition feed open
35 - Discriminating sensor open or missing
42 - Loop energy reserve voltage low
43 - Driver source feed low
51 - Frontal accident detected
52 - Data area full
53 - DERM driver initiator circuits high resistance
55 - DERM incompatibility
61 - SIR indicator circuit failure
62 - Redundant SIR indicator circuit failure
71/75 - Internal DERM fault
83 - Driver reserve diode shorted (history)

ABS system codes:
11 - ABS warning lamp circuit malfunction
14 - ABS enable relay contact circuit open
15 - ABS ERC circuit shorted to battery
16 - ABS relay coil circuit open
17 - ABS relay coil circuit shorted to ground
18 - ABS relay coil circuit shorted to battery/coil shorted
21 - Left front wheel speed = 0

More to come...fingers so tired...





'96 Z26 Now with 10% more displacement
'94 Camaro
Post Reply