Brights

Archived topics from the Diagnostic Help Forum
Post Reply
Guest

Brights

Post by Guest »

My brights are stuck on all the time. I think that the switch is broken(turn signal lever). I was curious how hard these are to replace.


Guest

Brights

Post by Guest »

You might just need to readjust the arm that actually pushes the high beam switch. I had to do it on mine. As a workaround, you can wedge a small stick (pencil, small screwdriver) perpendicular to the turn signal lever at the point where it pivots. This will give you enough leverage to hit the switch.
To adjust the arm, you have to remove the cover from the bottom of the steering wheel and contort yourself to access the small nut on the arm. Loosen nut, move arm towards the turn signal and tighten nut again. Test for effectiveness. There was an article somewhere on bnet, but I couldn't find it.


Guest

Brights

Post by Guest »

Thank you


Post Reply