Page 1 of 1
92 2.3 5 speed and ecm in a
Posted: Thu Feb 13, 2003 7:48 pm
by Guest
i need to know how hard it would be to swap my motor and trans and ecm into a 98 z24 2.4 with a automatic?
1. are the trans and motor mounts the same?
2. is the spacing the same for stuff to fit right?
3. what all is needed for the swap?
any information would help because this kid wants to put mine in his and i dont wanna sell it if it wont fit....
92 2.3 5 speed and ecm in a
Posted: Fri Feb 14, 2003 12:15 am
by rweatherford
I'd sell it and let him worry about it. It IS possible, but what a pain in the ###. He could just drive a Beretta.
92 2.3 5 speed and ecm in a
Posted: Mon Feb 17, 2003 10:36 pm
by Guest
A 92 to a 98 is going to be a pain in the @ss. I Did a 89 Beretta 2.8 5spd into a 91 Cavy 2.0 Auto and it was pretty straight forward. But Cavys were made with them in the Z24 model. SO!!!! WHO KNOWS?!?!?
92 2.3 5 speed and ecm in a
Posted: Wed Feb 19, 2003 1:02 pm
by Guest
It is possible but most likely illegal!!! In most states it is against the law to put an older motor into a newer car---especially an obdII car---you would be putting in an older obdI motor and computer into an OBDII car..that will nullify most of its emissions functions. I would check you local laws as you may get this whole job done, and take it for state inspection and get in serious trouble, the car get the registration revoked and so forth for messing with the emissions on the car....Quite a few states have adopted this. For it to be legal you would have to put a motor in a 98 model year car from a 98 model year car or newer if you are doing a drivetrain swap.
PLus it would be a total nightmare to ----the wiring alone would look like a butcher job, alot of repinning and rewiring---the newer cars have alot more sensors and wiring and systems they monitor comparitively....what is the advantage in doing something like this anyway?