Question About Beretta Potential

2001CamaroB4C · Post by **2001CamaroB4C** » Wed Aug 22, 2007 12:21 pm

Hi I do not have a beretta right now because I recently sold mine to get my Camaro.
But I am looking to get another one but I would want it to be able to run close to 14.00. What kind of mods would it take to get close, would a 3400 swap with some other minor mods make it or would it take forced induction or nitrous?

Also what kind of power is a stock V6 5 speed good for?

wicked-irocz · Post by **wicked-irocz** » Wed Aug 22, 2007 6:49 pm

a stock 3.1 v6 5 speed is 140hp I believe.

the 3100 is 160hp but only came with a 4t60-e.

the 3400 is rated up to 185 I think.

the fastest 3400 5 speed went 14.3

check out my list of 1/4 mile times in the drag racing section to find out what you would need.

Ribz80 · Post by **Ribz80** » Thu Aug 23, 2007 11:57 am

A well driven 3.1 5spd can hit 15.8-15.9. I saw a couple of stock 3.1's with 130k+ run 15.9's.

A 3400 5spd with headers, intake, full 2.5" exhaust and UDP and chip should hover around 14.0. If you add an LSD and drag radials high 13's.

leadfoot93 · Post by **leadfoot93** » Wed Aug 29, 2007 12:10 am

I'm trying to sell mine to buy a camaro too and it's already supercharged so you would just need the manual and an engine/build smaller pulley to hit 14'si should have the dyno numbers in a week if all goes well.

IsaacHayes · Post by **IsaacHayes** » Thu Sep 13, 2007 4:03 pm

A 5spd with 3400 swap, and a tuned chip (check out v6z24.com guys) with headers, UDP, and a cam would get you there. There's more you can do like 3500 stuff (top end, or just the plenum).

3100 with the auto's run usually between 16-17 sec. Mine ran a 16.0 but that's rare that they do that.

At any rate, 5spd is the way to go.

Asylum · Post by **Asylum** » Thu Sep 13, 2007 8:00 pm

3500 swap!

My 100% dead stock 2005 3500 ran 14.80's with a fubared 3t40 trans.

It has now run high 14.5's with a 3.73 FDR and an LSD, and will go quicker.

Still idles like a baby at 750 RPM.

The good part is, Me and some friends (Chris "domesticcrew.com" and Rodney "3400beretta on B'Stuff") have worked hard to make this OBD-1 chip work.

Hope this helps.

If you need more info on this swap "asylummotorsports@yahoo.ca" and I will answer your questions honestly, or direct you to Chris who actually did the swap.

Connect with your social network account