The Derretta, 1994 base with some attitude.

[whiteretta]

I definitely have my work "cut out" for me too...





Sent from my VS501 using Tapatalk

[themixer]

ahhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh.... that is not good

[3X00-Modified]

My Indy perches are REALLY good for a NY native car...

[themixer]

mods can we please lock/delete this thread, all this rust is giving me anxiety

[whiteretta]

My Indy perches are REALLY good for a NY native car...

IMG_20180322_070100.jpg

Hey, no holes! Good, haha.

Sent from my VS501 using Tapatalk

[whiteretta]

mods can we please lock/delete this thread, all this rust is giving me anxiety

Sorry man! Haha...

Sent from my VS501 using Tapatalk

[3X00-Modified]

mods can we please lock/delete this thread, all this rust is giving me anxiety

Look in your own garage and tell me the rust is giving you anxiety....

[themixer]

mods can we please lock/delete this thread, all this rust is giving me anxiety

Look in your own garage and tell me the rust is giving you anxiety....

There is only a rust free beretta in one, and a fiberglass trailer in the other. Anxiety starts in 3 weeks when the other two cars come out of storage.

[Rettax3]

...Since we are rubbing it in, I pulled the stock exhaust out of the '95 Z the other week in preparation for the new 3" pipes, and not even the bolts on the Cat-flange were rusted in! No torch, no PB Blaster, no ZEP-44, no broken bolts, just out they came...
Your car is looking great on the outside, obviously it is going to be as clean underneath when you are done. That is one lucky Beretta, glad to see the meticulous attention and quality you have going into her. BTW, I love those fender-stripes too, a few of my cars are going to get a similar treatment.

[whiteretta]

I'm trying to keep it clean everywhere at least! Haha.

Speaking of which, I was under it again yesterday and found that the section of the underbody between the spring perches, the section all the fuel and brake lines run along, is rotting from the inside out. I'll just scrape it down the best I can, paint it, and spray something inside of it. I do still have enough Rust Encapsulator left for the rear underbody. The fuel lines also look pretty rotted, but not leaking yet. Yet.

So it looks like it'll now be axle swap, disc swap, spring perch repair, and patching the fuel and brake lines in the rear.

Sent from my VS501 using Tapatalk

[3X00-Modified]

Yeah you found all the trouble spots on the rear of a Beretta that was driven in the winter....

[whiteretta]

Yeah you found all the trouble spots on the rear of a Beretta that was driven in the winter....

Yes I did, haha. It doesn't even see winter!

Sent from my VS501 using Tapatalk

[3X00-Modified]

It doesn't since you bought it... I'm sure it had in it's past otherwise it probably wouldn't be this bad.

[EPfiffner]

Fuggin Ohio...
Man it made me sick to see that photo, I've been following your thread with all the work you have put in to the new axle/disc conversion. Hope patching it up goes well.

[woody90gtz]

Eastwood has a "rust converter" or whatever that comes with a spray nozzle on a hose that you can spray inside. I used it on my camaro subframe after I blasted it.

Honestly you'd be better off cutting it out and replacing it though. Wouldn't be that hard to fab.