Beretta.net Forum

Submitted

yes takes alot of patience i noticed once i started lol. i need to get more paper, im doing this one to put on my gf's 99 lumina 3100. the 3400 throttle body is much larger, hopping the ports that meet the lower plenum are the same size to mate up. Also used my dremel a little where the seams are an...

this is alot of work, i started sanding a 3400 intake. only spent about an hour and half on it so far........... lots and lots and lots and lots of sanding it might look like yours lol...

the dash was a ton of work and still needs work, hopping to pull it out soon and touch it up and paint it as well. hard to do that right now when its all i have on the road to drive.

I hated to have to drive it in the snow, but it survived the winter.

i will be painting it the same blue. if i didnt have to put any body fill on it i wouldnt have to paint it at all, but was the only way i could fill everything in. But now i dont have a cup holder LOL, i could sit a large coffee in the hole behind the shifter before and fit perfect. I also want to f...

Modified my automatic center console cover to work with my 5 speed. spent a while searching for one and have come up with nothing so i gave this a shot. Had to cut some out of it for the boot to fit and used the cut pieces and plastic welded them with my soldering iron and a little body fill over it...

Them clamps on them are a pain in the ass too! Thats why they are called bastard clamps LOL. My fans never seemed to come on either but figured it was something with my wiring since i swapped the engine, i just hooked a ground to the relay and it runs soon as my key is turned on, since my temp gauge...

i have the same rims sitting in my basement pulled off a 89 GT

trying to keep my post on this topic so asking here... A 2002 sunfire im pretty sure a 4 cylinder. its a 5 speed, would the trans bolt up to my 3.1 L with my bell housing and what type of trans would it be ? would i be better off with the 2002 sunfire one or the 282 getrag i have now ? Might be able...

you should be able to go to the courts and get the info you need. pretty sure its quite possible long as there is no lean against it.
if anyone needs one for a 91 cavy i have one and the vin tag registered. Ontario Canada.

figured it out.... there was a loose fuse in the panel LMAO here i thought it was something drastic

This is Beretta. my internet is down and i dunno my darn password for the other account. so im using this for now, i had some water on my drivers floor and had fixed this back in the summer time but it was leaking again. i found it was coming in where my shifter cables run. I had a hair dryer in the...

having a problem with my car... it starts up and runs fine but the tach,amp gauge doesnt come on, it happend the other day in the day time and after driving half hour like this it randomly started working. never thought nothing more because it hasnt done it again. so tonight it done this again and w...