Beretta.net

No problem. Lots of parts on this base. Has red interior too.

cool yeah .....haven't decided yet but might be looking to get pass side??? rear quarter panel glass....mine has cracked/chiped edges on molding and same thing with rear glass molding is chewed up in some spots so i might be looking for that...... i dont think i can replace just the moldings.... think there all part with the glass.......also might want solid z26 style front grill if you had it still .......

Will have to see about the window glass. I only have one front bezel (grill), and its aqua and not going anywhere. lol I plan to keep most of the Z26 ground effect stuff off that car.

If you need a solid Z26 grill let me know I have a couple extra

Sent from my EVO LTE using Tapatalk 2

Hell, you should just drive your Beretta up here, and you can swap the glass over yourself. lol

I have pulled all the rear assembly, including the wiring harness. I still have to pull the spoiler, but its still under about 4 ft of snow at the moment. I will get to it though. Need to repair the 3rd brake light. But everything else looks good.

sounds good thanks again

Update. Weather cleared a small bit today. Shoveled my way to the scrap pile where I had the old decklid. Removed the spoiler for you. It did have one broken bolt (it was already broken before I got it) but all of the rest are good and tight, not stripped or anything. Have to see if I can get the old screws out that held the original 3rd brake light in yet though.

So all the parts are pulled, just have to go through, pack them and ship. I still have a few more things to pull for others yet too but will get all of it done soon.

Update. I have shipped the spoiler and the rear tail lights. Need to round up some more cardboard to custom box the lower filler and the lower support panel. I plan to keep them together, as I might damage them trying to take them apart. Also the upper filler. You should get the first two by Friday, will have track numbers UPS for you in a bit.

You will need to remove the old torx screws that used to hold in the original spoiler. I recommend a dremmel with a cutoff wheel. I will include fasteners with the rebuilt 3rd brake from my Aqua Z.

thanks for the update