Beretta.net

i have the flywheel cover and wheel well plastic for passenger side no holes ripped, but the size of the box to ship is going to be huge unless i can fold it around and squeeze it in a smaller box without wrecking it.

going to check out the condition of the shift plate in my 96 the one in the 94 i just got i think the lettering is wore i dont care what one i have in my own car so i can swap them if mine is good.

ok thanx dude

still need a mint shift plate!

why buy a mint one that will cost a good dime and not pay some one to pin strip the while back on a faded one?

Or could make a decal to go exactly over where the original letters are. Could be done easily I would imagine.

The letters look raised to me im not positive though

Cost is no object, i have money and i need a mint one asap

Having somebody paint that lettering isn't gonna happen, then lettering isn't raised, and a decal would be a good possibility and may hold up/look better than the OE stamped writing. Has anyone noticed that the OE stamped on writing is quite crooked on them! LMAO!

DITTO scd

More added

Still needed..

Where are you located?

I believe I have a very nice auto shift plate (two actually, but one is in use on the Beretta) It does not have a trunk release button on it, but it is easy to fit one to it (I did on the one I used)

I'll have to check again but I believe that the writing on it is intact as well. Not sure of the year, but IIRC its almost black whereas the one I used on mine is a bluish/gray color. I think the ribbon for the shifter is a bit wrinkled on it but that can be swapped easily I believe.

I am located at 15666
And i dont need the ribbon ect, just the actual black plate with good writing on it, i also now need a window switch cover with good writing as well, pm me a pic if possible and lmk a price shipped thanx!

Ah, I just checked it a bit ago and I was wrong about the writing, the writing on this one is completely gone.

Sadfaceeee..

updated, got cash still need this stufff