Beretta.net

alpine, it's all mandrel bent, yes. I don't do non-mandrel, period. I have the 2.5" listed with a picture/price of it on the first page of this thread.

Geoff, yes, that is what I refer to as a cat-back.

So just curious cause the price on the first page still says TBD how much would the catback be I would have the cash for it next week Let me know Thanks Alot



Alex

id be looking at 250-300+shipping. price in ss went way up this year.

which may i add, is STUPID cheap. you can barely pick up a ss catback for a honda for that price

The 2.5" catback is $150+shipping.

Sorry I never updated the first page.

Thats Is crazy cheap, Umm i need it for a week into the new year when im paid next, Can you find out what shipping will most likely cost so i know what to expect to ship that bad boy here Zip is 49504

hey dustin i was wondering if you make a 3400 dp for just one person. im looking to 3400 swap my new i just got most likely before spring time. Would you be willing to make one for me? i can pay half up front or whatever needed to do. just let me know please.

Hey everyone, I bent some pipes up and have 2 that are not spoken for currently.

1 is "good" and 1 is what I will call a builder series as in 1 of the bends was off so either I can sell it as is with a correct bend included or I can sell it fixed but with a weld joint. The price as is: $100+shipping. The price fixed: $125.

I will do 1 off parts including a 3400 DP. Is anyone else still interested in a 3400 DP?

Kris, I need your address, please PM it to me. I lost it when the other site went down. Your exhaust is ready to ship. It's actually been ready for awhile, just been crazy busy moving and have had very limited access to the internet.

What do you mean "bent up some pipes" for the cat back or downpipe? If its for over the rear muffler ill take one set

Dusty, you sir, are a badass and a saint.

dusty ill be getting a 3400 dp from you moist likely mid february if thats cool? just let me know what i need to do in order to get a dp from you. its 80+ shipping?

you da man wicked

Kris, you have a PM

Alpine, yes, I bent cat-backs. Do you want the builder one since you may have to cut it anyway? Your shipping cost is $50.

13's or Bust, I can't do a 5 piece price for a 1 piece order. I will send you a quote via PM.

Anyway you can fab up a cat back for a plastic tank? Or is it just to close?

Im not keen on switching to a metal tank.

I will do one for you if I can locate a car with a plastic tank. The price will be a 1 piece price, not a group buy price unless you can get a group together. I don't know anyone with a plastic tank right now other than you. You comming to Nitrofest this year?

Yessir, but the car probably wont be there. Engine block will still be at the machine shop.