Page 4 of 6
Re: Hello from Ukraine. Pontiac Tempest
Posted: Fri Aug 19, 2011 12:16 pm
by Bosic
weba wrote:I am 99% sure that there is not a single Opel piece that would fit this car.
Just get the correct parts from rockauto.com.
already found. The control arm of the Opel Ascona C
Rear shocks from Opel Kaddet
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Aug 24, 2011 7:54 am
by Bosic
changed the front lever.
I found a substitute family.
Opel Ascona C

Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Aug 24, 2011 4:20 pm
by JiminGA
Bosic, it looks like you have the inginuity to maintain and upgrade what is a rare car in your homeland. It will certainly make me think twice about complaining about parts availabilty in the US.
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Aug 24, 2011 6:42 pm
by Money pit Beretta
Looks close. When will you get to check them on the car?
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Aug 24, 2011 7:08 pm
by ErichZ26
Yes those should work. Unfortunately the brakes are slightly different on that earlier J body car.
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Aug 24, 2011 9:54 pm
by Cliff8928
From what I've seen in the pictures the Opel is significantly different in that it uses a 4-lug pattern.
Re: Hello from Ukraine. Pontiac Tempest
Posted: Thu Aug 25, 2011 2:29 am
by Bosic
JiminGA wrote:Bosic, it looks like you have the inginuity to maintain and upgrade what is a rare car in your homeland. It will certainly make me think twice about complaining about parts availabilty in the US.
already established. established as a native
Re: Hello from Ukraine. Pontiac Tempest
Posted: Thu Aug 25, 2011 11:51 am
by ErichZ26
Cliff8928 wrote:From what I've seen in the pictures the Opel is significantly different in that it uses a 4-lug pattern.
I notice this too. However the C is a J body design. The next thing someone in this group will to do is get those 4 lug bearings and rotors for a 5 to 4 lug conversion to match their fugly euro tail lights

Re: Hello from Ukraine. Pontiac Tempest
Posted: Fri Aug 26, 2011 2:08 am
by daguse5853z
looks like someone in the cars previous life probably just ditched the egr when it went bad and installed a block off plate. I'd almost bet the plug is tucked in the wiring.
As with the opel story....well you learn something new everyday! lol sort of like the toyota cavalier!
http://en.wikipedia.org/wiki/Opel_Ascona
http://en.wikipedia.org/wiki/File:Toyot ... export.jpg
Welcome!
I shipped a chevelle header panel to Weba 5 or 6 years ago, a brand new goodmark one none the less, and shipping was more then cost of the part. It was oversized to make things worse.
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Sep 21, 2011 3:36 am
by Bosic
changed front brake discs
Re: Hello from Ukraine. Pontiac Tempest
Posted: Wed Sep 21, 2011 5:00 pm
by Money pit Beretta
Looking good Bosic. Where is the wheel stud?
Re: Hello from Ukraine. Pontiac Tempest
Posted: Thu Sep 22, 2011 3:02 am
by Bosic
Money pit Beretta wrote:Looking good Bosic. Where is the wheel stud?
I do not know. I bought a car and there was no studs
Re: Hello from Ukraine. Pontiac Tempest
Posted: Thu Sep 22, 2011 3:04 am
by Bosic
That he was so I had six months ago.
Before and after painting.
And how does he wants to be:)
Re: Hello from Ukraine. Pontiac Tempest
Posted: Thu Sep 22, 2011 1:22 pm
by scd88ga
Replace your wheel stud, it's there for a reason! Nice car btw!

Re: Hello from Ukraine. Pontiac Tempest
Posted: Fri Sep 23, 2011 5:57 am
by Bosic
HID Xenon 4300K