Page 1 of 1
WTB: 1992+ Intermediate/Jack shaft
Posted: Fri Apr 12, 2013 7:30 am
by DanteGTZ
I am looking for an intermediate/jack shaft from a 1992+ Quad4/TC car. It needs to have the same mount/bolt pattern as the one pictured on the bottom. Please let me know if you can help!
My project is dead in the water until I find one!
Re: WTB: 1992+ Intermediate/Jack shaft
Posted: Fri Apr 12, 2013 7:51 am
by Alpinestar10
If im not mistaken the bracket is swappable between the two shafts. So if your bracts is good all youd need is any shaft.
Re: WTB: 1992+ Intermediate/Jack shaft
Posted: Fri Apr 12, 2013 8:56 am
by woody90gtz
If that is true, I have a spare shaft.
Re: WTB: 1992+ Intermediate/Jack shaft
Posted: Fri Apr 12, 2013 1:25 pm
by 3400beretta
Just an FYI, the quad shaft is about 3/4 of an inch longer or shorter than the V6 (I cannot remember which is which, but one is definitely shorter than the other).
Re: WTB: 1992+ Intermediate/Jack shaft
Posted: Fri Apr 12, 2013 3:23 pm
by woody90gtz
Nvm then. Makes sense since 4 cylinders would take up more room than two sets of 3.
Re: WTB: 1992+ Intermediate/Jack shaft
Posted: Sat Apr 13, 2013 1:19 pm
by Alpinestar10
Ok, Then i guess its only for the v6 brackets/shafts.