Beretta.net Forum

So I have a 90 base 2.2L Beretta I bought recently, I cannot for the life of me figure out how to get the blower to blow at all. The fuse used to pop. I have replaced the blower motor, resistor, resistor plug with about 1 1/2 feet of wire soldered in, looked through the harness in the engine bay (which looked good) Then I went into the cabin where all the switches are found a melted wire that goes to the switch that controls what area it blows, soldered in a new wire all the way up where it melted, (I did bypass a plug but did not seem to be any more than a plug) and the only progress I’ve made after all of that was the Fuse stopped blowing immediately.

Please if someone knows a bit more and can help I would very greatly appreciate it.