Beretta.net

Well I was working on my dad's friend's truck and I had to use our air jack. (put under frame lifts with air pressure)  I was thinkin damn this would be nice on a beretta.  I was just wondering if anyone has tried or even thought about this?  Just a shot in the dark.

If you support the car properly you should have no problems.  You have to use the proper lift points for a unibody car since there is basically no frame.

I guess I'd have to have a picture of the lift to get some idea if it would work.  If it is made to go at the end of the car near the bumper I would probably forget the idea.

Well here is a picture!

That's what I was afraid of.  We have one of those in the shop.

One on each side perhaps... if done properly.  Not on the ends of the car.

Humm I guess I rather have some lift than none.