Beretta.net

My build on my 93 GT has changed directions so I'm looking to sell these spacers. They are 1.25" thick and would work well for direct port nitrous.

They have oring seals on both sides and so far as I know are one of two sets of this thickness made by TCE.

I'm asking $50 and you pay shipping from 52501. Itd be $10 or less I'd imagine within the states.

is there anyway you could post pics with a 3500 gasket on top of them?

I am interested and have been looking for these but need them to work on a 3500 uim

thanx!

Yeah thats my issue as well, and I would want something aluminum to thread fogger nozzles into though.

Ill take one to work tomorrow and see if we have a gasket. If we don't ill order a pack. Hopefully on Monday ill have high speed here at the house. Doing everything from my phone blows.

BTW this is for the help Kurt buy a muffler so he can fully finish his exhaust in 2.5" goodness fund.

well if they will work with my 3500 upper and 3400 lower ported to the 3500 upper than i deff want em.

LOL at the Kurt muffler fund...

FYI... They use different gaskets depending on what you buy... IIRC the paper 3500 ones sold are the same size as the 3400 ones, BUT if you go and buy the GM metal/rubber ones they are larger than the 3400 gaskets.

Unfortunately all my stuff is ported to the 3500 metal/rubber ones so thats why I need stuff made to the 3500 spec.

Kurt if you want I can get a measurment of that gasket and throw up a scaled scan image of it.

For someone who does buy it though if you bring it to a machine shop it should be a simple project for them to open it up, but if they do you'll have to scrap the o-rings and mill that much off each side of them... The original 3500 ones they made before that I bought had too thin of a inside wall around the o-ring groove so when I tightened them down the o-ring expanded and split the inner wall off almost going in my motor. Mine are now shaved down and have the metal/rubber gaskets on each side.

Dynomax VT muffler?

So before i install my 3500 uim and lim i should have them ported??

Any pix kflo?

Well... my gaskets got sent back to warehouse before I could get pix. Also my only internet is my phone... no high speed at the house probably forever until I move.

Ill update next time I get to a buddy's place with wireless.

I did order more gaskets under the name Jon Little. Heh

KFLO 93 GT wrote:I did order more gaskets under the name Jon Little. Heh

lol

Lol nice.

I think that phenloic would be plenty stable to tap for n2o nozzles. Especially being that thick.

What ever happened with these spacers?

I haz them, and I would like to sell them.

I will be getting them off of you either this pay or the next deff