Beretta.net

Thanks everyone for your interest. These have been sold to Z26_T.

I have a very good set of window dew strips for sale. The outer black plastic trim could some cleaning and polishing, but is not cracked or peeling. The rubber strips are in very soft and pliable condition. I purchased these for my '93 GT, but was rear ended and my car totaled before I could install...

Thanks for the reply. PM sent

Do you still have these side skirts available? If so, I would like all pieces. Thanks.

Pm sent.

Wouldn't happen to still have the Z26 bumpers and side skirts would you?

Well I have finally been outbid!

Barry wrote:Pre 95 bump stops are on bottom.


While your in there sand off the rust and re paint the area under the insulators. It's a serious rust area

Thanks for the tip, I will do that. Thanks guys for the part numbers. This should help.

Hey gang. Anyone have a source for new rear spring insulators for a '93 GT? I especially need the lower ones with the bump stops. I have searched at all the usual parts stores, including Rock Auto and GM Direct, but have found nothing available. Thanks for any info you might have.

Thanks for your input. I have been searching my local salvage yards for two years now. I usually hit the Pull-A-Part yards once a month. I have yet to find a Beretta or Corsica with seats any better than my own. All that I have found have torn and shredded fabric and rotting foam just like my own. I...

Has anyone put Cavalier seats in their Beretta? I know they are not a direct bolt in, and would require drilling holes in the floor. I am just wondering if anyone else has used any from a '95 up Cavalier and if so, how do you like them?

That is an awesome Beretta. Where did the front grill come from? I've never seen a Beretta grill like this.