Rear brake backing plate

[heavywoody]

I need one since I damaged mine removing a bearing (the bolt stripped out and the only option was to cut it with a die grinder, and the cut wheel went into the backing plate a little).

I can use mine if I have to, but I'd rather not if I can help it.

It would be perfect if it could be shipped out this week so I could get it by Friday/Saturday so I can put the car back together this weekend.

Paypal ready, shipping is to 28027.

Thanks!

[SummitBalt08]

Dang man just stripped that GTZ yesterday. Could have grabbed it off of there.

Sent from my EVO LTE using Tapatalk 2

[Money pit Beretta]

When I had a problem with a bolt on my 90 I went to the auto parts store to try to get the backing plate. I found out it was the same as a Camaro, but I don't remember what years. I think it was third gen.

[heavywoody]

I see them on Advance Auto Part's site, but no picture to verify. It's pretty cheap, $15, compared to the one I found on eBay for $66.

[woody90gtz]

I have a pair in really nice shape. They are just missing the center section where they mount to the axle. haha

Can you just weld the cut mark in yours?

[heavywoody]

I could, I'll probably just do that and be done with it. I haven't even looked at it to see how bad the cut is, I just saw it when I was spraying PB blaster on the brake lines going into the wheel cylinders. Hopefully the line doesn't break when I replace the wheel cylinders... damn MI car.

I can't complain too much though; I haven't touched the back brakes in the 14 years of ownership, and they still have about 3/16" of material on the shoes.

[DTMAce]

Worst case, let me know, I will pull one off the base for you Woody.

[Cliff8928]

They still appear to be available from GM.


18014165 (right) and 18014164 (left) are the part numbers.

[heavywoody]

Good to know; I don't think mine is bad enough to warrant spending $70-80 on one though.

[Money pit Beretta]

Yes but they are so pretty when they are new. All that nice black paint! Makes you feel like you have a new car(lol).

[SummitBalt08]

Swap to disc in the rear! Lol

Sent from my EVO LTE using Tapatalk 2

[woody90gtz]

I could, I'll probably just do that and be done with it. I haven't even looked at it to see how bad the cut is, I just saw it when I was spraying PB blaster on the brake lines going into the wheel cylinders. Hopefully the line doesn't break when I replace the wheel cylinders... damn MI car.

I can't complain too much though; I haven't touched the back brakes in the 14 years of ownership, and they still have about 3/16" of material on the shoes.

Yeah, I've realized how much front bias these cars have after testing the pressure out of the master cylinder. Stock it's 1400psi front, 500 rear.

[heavywoody]

The plan is to do a rear disk conversion, but I highly doubt I'll have all the parts together and ready to go on the car before heading west. I'm trying to get the car driveable for a trip north in the next two weeks...

[3X00-Modified]

I can send these to you tomorrow if you still need them.