Solid GTZ/Z26 Grill

SuzukiGhostRider · Post by **SuzukiGhostRider** » Sat Apr 26, 2008 3:02 am

I would like a z26/gtz grill. It needs to be gouge free for the most part. I'm not talking about rock chips in the paint as I will be sanding it smooth and painting it anyway. I'm talking about gouges or chunks outta the plastic itself. Please let me know if you have one and what you're looking to get for it. Thanks.
Mike

Mike Morris · Post by **Mike Morris** » Sat Apr 26, 2008 9:45 pm

My local yard has them. I think they charge $20. I will be happy to go pull one for you.

SuzukiGhostRider · Post by **SuzukiGhostRider** » Sat Apr 26, 2008 11:23 pm

Nice , would you mind? Thanks Mike.

Mike Morris · Post by **Mike Morris** » Sun Apr 27, 2008 2:44 pm

Ill go up there tomorrow. Tool wise what do I need to yank it?

SuzukiGhostRider · Post by **SuzukiGhostRider** » Sun Apr 27, 2008 3:16 pm

Should just be a phillips screwdriver if I remember correctly. I didn't pull this one. It was already off the car. I would take a small socket set and a flathead screwdriver too just to be safe.

Mike Morris · Post by **Mike Morris** » Mon Apr 28, 2008 5:49 pm

It rained here in MD. I will try tomorrow.

SuzukiGhostRider · Post by **SuzukiGhostRider** » Tue Apr 29, 2008 12:06 am

Got to looking at mine Mike. I THINK they just snap on with plastic fasteners. Thx again, and np. Let me know what ya find.

Post by **snowblindburd** » Tue Apr 29, 2008 3:59 pm

IIRC 7mm socket on the top three bolts, and I forget what size is used on the inner bracket bolts. Those might be just screws but I don't remember.

Mike Morris · Post by **Mike Morris** » Sun May 04, 2008 7:14 pm

I got two off practicing. Not good enough for your terms-deep dents. However I am headed to another pick and pull. If they have a good one-and its cheap Ill buy it for you and post pics.

Post by **snowblindburd** » Sun May 04, 2008 8:05 pm

Curious, were the top three 7mm? And how were the lower brackets attached? Just wanted to know for future reference.

speedygtz · Post by **speedygtz** » Mon May 05, 2008 12:14 pm

not sure bout the top sizes... but i know theres clips on the bottom that hold the bottom of the grill in wich will be needed, and they are also taken off with a wrench, if your anything like me, when i went i was with my buddie and just browsed around the gm section quick, found a solid grill and only had a needle nose, did the job very well actually.... so if you still need the grill, i would trade you for something.

SuzukiGhostRider · Post by **SuzukiGhostRider** » Mon May 05, 2008 10:30 pm

Yes Speedy, I still need the grill. Mike thx for trying , let me know what you come up with at the other yard.

APACHE 64D · Post by **APACHE 64D** » Fri May 09, 2008 3:27 pm

i've got a maroon red gtz one if you still want one. $20 if you pay for shipping.

Connect with your social network account