lumina euro grille...

ohiorunner · Post by **ohiorunner** » Mon Aug 23, 2010 3:02 pm

i was wondering if the lumina euro grille will fit where the stock one goes... i want to put it in my 88 gt... i am putting the z26 kit on it and wanted to make the bumper lights in the new bumper one for light and one driving light on each side.. that leaves me with putting the turn signal some where else.. the lumina euro grille has the turn signal in the grill already... its just a though but would like to know your guys opinion before i start buying stuff...this is what im talking about...

Asylum · Post by **Asylum** » Mon Aug 23, 2010 4:56 pm

Nope!

ohiorunner · Post by **ohiorunner** » Mon Aug 23, 2010 10:32 pm

nope what... is it just to big or what...

2.2H8TA · Post by **2.2H8TA** » Mon Aug 23, 2010 11:49 pm

I think it's too big, you'd have to cut it or something to get it to fit, and if you did that there would not be enough room for the blinker lights. In my opinion, just take a base or gt grill, and get some small amber lights that can be used for blinkers and put em in one of the slots. Or get a Z grill, and cut small rectangular holes in it and do the same thing. Good idea, hope you find a way to get it done.

Asylum · Post by **Asylum** » Tue Aug 24, 2010 10:52 am

ohiorunner wrote:nope what... is it just to big or what...

It's too wide and too tall and would require alot of cutting, and fabricating, but then a tape measure would have told you that.

The Solid grille has been modified by a couple of people with louvers on either side and lights installed behind it, or as suggested use the eggcrate grille and install lights behind that.

ohiorunner · Post by **ohiorunner** » Wed Aug 25, 2010 3:49 pm

ok thanks man i just have been working alot and havent been able to get one measured...i will prolly go for a solid z grille and do the lights behind it...

Beretta.net