92+ upper engine mount bracket

Kris GTwhat? · Post by **Kris GTwhat?** » Thu Jun 02, 2011 2:01 pm

I'm looking to see if anyone has one of these to spare. I'm converting my gtz to 92+ mounts before I swap to my 3500, so I need the piece that's actually spot welded to the strut tower. Any help is appreciated!

speedy · Post by **speedy** » Thu Jun 02, 2011 7:51 pm

what are your plans for the old wiring harness, computer, ect??

Kris GTwhat? · Post by **Kris GTwhat?** » Thu Jun 02, 2011 9:45 pm

You want it? When I pull it ill sell it to ya dirt cheap if you're interested?

woody90gtz · Post by **woody90gtz** » Thu Jun 02, 2011 11:06 pm

You actually need the strut tower sheet metal too, not just the spot welded bracket. I did this on my car a couple years ago.

Kris GTwhat? · Post by **Kris GTwhat?** » Fri Jun 03, 2011 10:49 am

Woody that's exactly what I'm after. It'd be cake if I could find one sittin in the yard without a motor

Chad91GTZ · Post by **Chad91GTZ** » Fri Jun 03, 2011 10:54 am

Yeah I hit that snag thinking it was just the mount. The physical shape of the fender well is different. You're probably a good welder or know someone who is, but that needs to be done up right. Seen a guy with a welder that only had the birdshit setting pretty much twist that right outta the car. There are quite a few 92+ berettas in the yards around here. I'd be willing to cut one out if you don't find one. Might just get two or three for posterity.

Beretta.net