95+ lower Rear Shock Mounts

[3X00-Modified]

Ok since I'm trying out a set of Bilstein's I need the lower shock mounts that cam with the 95+ Monroe and similar shocks. Since I have KYB's they are integrated into the shock itself and are not bolted. See pics.

No bolt on the lower shock bracket, Its just a flared collar.



I need the silver bracket with the stud and nut thats shown in these shock photos.

[scd88ga]

Jon, I will take a look at the local yards this week while I'm out n about. Here's a list of all the cars that use the same rear shock.
BUICK SKYLARK (1995 - 1998)
CHEVROLET BERETTA (1995 - 1996)
CHEVROLET CORSICA (1995 - 1996)
OLDSMOBILE ACHIEVA (1995 - 1998)
PONTIAC GRAND AM (1995 - 1998)

[3X00-Modified]

Don't kill yourself to get two, I only need one since I found one in a box... I have to have a second floating around SOMEWHERE but thats the issue... I may never find it before I need it.

[berettaboi]

do you want the bottom shock mount off of a stock shock? the one with the flared tube holding the shock to the bracket? or specifically looking for the 'meant to be bolted in bracket'? i just replaced my rear shocks and can send you the bottom mounts... they are just as yours are except for the 'rear sway bar mount'

[scd88ga]

do you want the bottom shock mount off of a stock shock? the one with the flared tube holding the shock to the bracket? or specifically looking for the 'meant to be bolted in bracket'?

I need the silver bracket with the stud and nut thats shown in these shock photos.

[berettaboi]

with a bit of thought you could pop out the flared fitting and then you have that...

[3X00-Modified]

I'm doing a test fit with some unknown shocks. I don't want to dismantle what I have, I also know that the metal brackets that come with the aftermarket shocks are made to do what I want with them. If the holes on the bracket thats flared together are way larger than the holes through the shock itself I end up with a very sloppy fit that could make noise and move.

I'm trying to start with the pieces that were meant for what I'm trying to do to ensure it will work properly... also I do not want to take my shocks apart like that I want to keep my KYB's intact.

[3X00-Modified]

Still need one...

[scd88ga]

I'm trying to find one that doesn't look like it's been in Wisconsin for 15 years! lol

[99GaGT3X00]

Still need one...

i actually have two brand new ones i never used since the old ones wouldn't come off the car but they are yours if you want them.

bolt, nut, whole deal

[3X00-Modified]

Yes I'll take them!

[99GaGT3X00]

Pretty sure i kept the big bolt that goes through the bottom of tje shocks too.

I'll dig them out friday and whether you want to meet on a sat or what ever its up to you..

[3X00-Modified]

That will be the hard part... I'm busy this weekend, Gone to Bfest next week, and pretty busy almost every weekend till end of the summer... Damn racing.

It looks like I will have the Bilstein's before Bfest but I don't think I want to take on installing them since I am busy the rest of this week.. its bad enough the cars not ready and I'm not going to be home after work till friday...

[99GaGT3X00]

if your going to wait till after bfest i could shoot down the friday after that. which ever scenario works for you.

[3X00-Modified]

I'm going to have to wait... I don't have time to install them before bfest anyways. I want to do more testing with them before final install too, Friday the 29th you can head down?